9
■ Turn the breaker ON
• Turning ON the breaker opens the flap, then closes it again. (This is a normal procedure.)
NOTE
■
■■
■
Tips for saving energy
•
Be careful not to cool (heat) the room too much.
Keeping the temperature setting at a moderate level helps save energy.
•
Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors increases the cooling (heating)
effect.
•
Clogged air filters cause inefficient operation and waste energy. Clean them once in about every two weeks.
■
■■
■
Please note
•
The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
•
If you are not going to use the air conditioner for a long period, for example in spring or autumn, turn the breaker
OFF.
•
If the flap opens, turn on the breaker to close it.
•
Use the air conditioner in the following conditions.
•
Operation outside this humidity or temperature range may cause a safety device to disable the system.
Recommended temperature setting
For cooling: 26°C – 28°C
For heating: 20°C – 24°C
Mode Operating conditions If operation is continued out of this range
COOL
Outdoor temperature: 15 to 46°C
Indoor temperature: 18 to 32°C
Indoor humidity: 80% max.
•
A safety device may work to stop the operation.
•
Condensation may occur on the indoor unit and drip.
HEAT
Outdoor temperature: –10 to 20°C
Indoor temperature: 14 to 28°C
•
A safety device may work to stop the operation.
DRY
Outdoor temperature: 15 to 46°C
Indoor temperature: 18 to 32°C
Indoor humidity: 80% max.
•
A safety device may work to stop the operation.
• Condensation may occur on the indoor unit and drip.
01_EN_3P147100-4H.fm Page 9 Thursday, October 27, 2005 10:12 AM