Need help?Do you have a question about the Daikin FTYN25KV1A and is the answer not in the manual?
General| Brand | Daikin |
|---|---|
| Model | FTYN25KV1A |
| Category | Air Conditioner |
| Language | English |
Instructions on how to remove the air filters from the unit.
Procedure to remove the titanium apatite photocatalytic air-purifying filters.
Procedure to unfasten hooks and remove the front grille.
Instructions to remove the large horizontal blade, including shaft detachment.
Instructions to remove the small horizontal blade, including shaft detachment.
Steps to detach pivots, remove interlock rod, and unfasten hooks for vertical blades.
Procedure to remove the vertical blade assembly, noting fin count.
Instructions to remove terminal board screws and disconnect wires.
Final step to lift and remove the electrical box.
Steps to lift and unfasten lower hooks to remove the shield plate.
Instructions to unfasten hooks and remove the signal receiver unit.
Procedure to unfasten hooks and remove the INTELLIGENT EYE sensor PCB.
Procedure to unfasten hooks and remove the signal receiver PCB.
Procedure to remove the display PCB.
Steps to unfasten 4 hooks and remove the display PCB.
Procedure to remove the control PCB.
Procedure to remove the signal receiver PCB by unfastening three hooks.
Procedure to detach the signal receiver unit.
Procedure to detach the display PCB by unfastening four hooks.
Final step to remove the control PCB.
Instructions to lift unit, remove screws for vertical swing motors.
Procedure to remove swing motors for horizontal blades, noting connector colors.
Instructions to remove 3 screws and disconnect connectors for horizontal swing motors.
Procedure to disconnect refrigerant piping by removing screws.
Instructions to disconnect the gas and liquid piping.
Procedure to remove the indoor heat exchanger.
Final step to remove the indoor heat exchanger.
Procedure to remove the fan motor.
To Next Page
