15
■ To use ON TIMER operation
1. Press “ON TIMER button”.
•
The time changes in 1 hour increments every time
the button is pushed, with a maximum of 12 hours.
■ To cancel ON TIMER operation
2. Press “CANCEL button”.
•
The TIMER lamp goes off.
■ To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
ATTENTION
■
■■
■
In the following cases, set the timer again.
•
After a breaker has turned OFF.
•
After a power failure.
•
After replacing batteries in the remote controller.
1
2
The TIMER lamp
lights up.
Display
(Example)
The air conditioner is currently
operating. You want to have it run for
another hour, then stop for 7 hours,
then start up again.
01_EN_3P147100-4H.fm Page 15 Thursday, October 27, 2005 10:12 AM
To Next Page
Loading...
