To Next PageTo Next PageWhat to do if my Daikin FTYN35LV1B Air Conditioner unit does not operate?
If your Daikin Air Conditioner unit isn't operating, here are a few things to check: - Check the power supply, as there may be a power failure or a blown fuse. - Ensure the power plug is properly connected; reconnect it if it's loose. - Verify the delay timer setting to make sure it's correctly configured.
Why is the airflow too low in my Daikin FTYN35LV1B Air Conditioner?
Low airflow in your Daikin Air Conditioner can be due to several reasons: - The air filter might be dirty, so you should clean it. - Doors or windows might be open, so close them. - The air suction and discharge could be clogged, so unclog them. - The regulated temperature might not be high enough, so increase it.
How to fix bad odor from Daikin FTYN35LV1B Air Conditioner discharge air flow?
A bad odor from your Daikin Air Conditioner's discharge airflow may be caused by particles from cigarettes, smoke, or perfume that have stuck to the coil. To resolve this, clean the coil.
Why is there condensation on the front air grille of my Daikin Air Conditioner indoor unit?
Condensation on the front air grille of your Daikin Air Conditioner's indoor unit can occur due to air humidity after extended operation or if the set temperature is too low. Increase the temperature setting and operate the unit at high fan speed.
Why doesn't the compressor start immediately on my Daikin FTYN35LV1B Air Conditioner?
If the compressor in your Daikin Air Conditioner doesn't start immediately, wait for 3 to 4 minutes after starting the unit for the compressor to begin operating.
General| Brand | Daikin |
|---|---|
| Model | FTYN35LV1B |
| Category | Air Conditioner |
| Language | English |
Lists critical safety warnings and cautions for installation and operation, including electrical hazards and sharp edges.
Details information about the R410A refrigerant, including GWP and handling precautions.
Illustrates the installation placement and clearances for the indoor unit.
Specifies the required minimum clearances around the outdoor unit for proper airflow and service access.
Details electrical wiring requirements, cable sizes, conductor counts, and connection procedures.
Lists specific precautions when working with the R410A refrigerant system.
Details the meaning of various LED indicator light patterns for normal operation and fault conditions.
Lists common faults, their causes, and recommended actions for troubleshooting.
