What to do if my Daikin FVQ100CVEB Air Conditioner does not operate at all?
If your Daikin Air Conditioner isn't operating, check the following: * Ensure no fuse has blown. Turn off the power supply. * See if the power circuit breaker is blown. Turn the power on with the power circuit breaker switch in the off position. * Check for a power failure. Wait until power is restored.
What to do if water leaks from Daikin FVQ100CVEB Air Conditioner unit?
If water is leaking from your Daikin Air Conditioner unit, stop the operation immediately.
What to do if the ON/OFF switch does not properly work on my Daikin FVQ100CVEB?
If the ON/OFF switch on your Daikin Air Conditioner does not work properly, turn off the main power switch.
What to do if Daikin Air Conditioner detects multiple master units?
If your Daikin Air Conditioner detects multiple master units, connect the remote controller to only one indoor unit.
What to do if Daikin FVQ100CVEB has gas shortage due to clogging in refrigerant piping?
If you suspect clogging in the refrigerant piping system of your Daikin Air Conditioner, check for a failure to open the stop valve and any clogging within the refrigerant system.
What does excess indoor units connected error mean on Daikin FVQ100CVEB?
This error will be displayed if five or more indoor units are connected to your Daikin Air Conditioner.
Why Daikin FVQ100CVEB unit started or stopped without pressing the on/off button?
If your Daikin Air Conditioner started or stopped without pressing the ON/OFF button: * Verify that the ON/OFF timer operation is not in use. Turn off the ON/OFF timer. * Check if a remote control device is connected. Contact the central control room that directed the stop. * See if the display for centralized control is lit. Contact the central control room that directed the stop.
What to do if a safety device frequently actuates on Daikin FVQ100CVEB Air Conditioner?
If a safety device such as a fuse, a power circuit breaker, or an earth leakage breaker frequently actuates on your Daikin Air Conditioner, do not turn on the main power switch.
Why does my Daikin Heat Pump emit an odor?
If your Daikin Heat Pump emits an odor, it's likely due to room smells and cigarette odors that have accumulated inside the indoor unit. To resolve this, the inside of the indoor unit must be cleaned.
Why Daikin Air Conditioner does not sufficiently cool or heat?
There are several reasons why your Daikin Air Conditioner might not be cooling or heating sufficiently: * The air inlet or outlet of the indoor or outdoor unit may be blocked by obstacles. Remove any obstacles to ensure proper ventilation. * The air filter may be clogged. A qualified service person should clean the air filters. * The set temperature may not be appropriate. Adjust the temperature, airflow rate, and discharge direction accordingly. * The FAN SPEED button may be set to LOW SPEED. Adjust the settings for optimal performance. * The airflow angle may not be proper. Adjust the airflow angle. * Doors or windows may be open, allowing wind to enter. Close them to prevent this. * Direct sunlight may be entering the room (when cooling). Use curtains or blinds to block s...
Precautions for group or dual remote control systems.
Identifies and explains the function of various parts of the unit.
Guidance on selecting suitable locations, avoiding problematic areas.
Instructions for proper electrical wiring and authorized personnel.
Considerations for installation site to minimize noise and vibrations.
Proper installation of drain piping to ensure complete drainage.
Explains cooling operation, auto cooling, and defrost mode.
Covers heating operation, start-up, and defrost.
How outside air temperature affects heating capacity and potential issues.
Adjusting airflow horizontally using the remote controller.
Adjusting airflow vertically manually.
Instructions for cleaning the air filter when the indicator appears.
Cleaning instructions for external parts and the remote control.
Steps to check when the unit is completely unresponsive.
Checks for issues when the system stops after normal operation.
Diagnosing insufficient cooling or heating performance.
Investigating unexpected unit start or stop events.
Precautions for group or dual remote control systems.
Identifies and explains the function of various parts of the unit.
Guidance on selecting suitable locations, avoiding problematic areas.
Instructions for proper electrical wiring and authorized personnel.
Considerations for installation site to minimize noise and vibrations.
Proper installation of drain piping to ensure complete drainage.
Explains cooling operation, auto cooling, and defrost mode.
Covers heating operation, start-up, and defrost.
How outside air temperature affects heating capacity and potential issues.
Adjusting airflow horizontally using the remote controller.
Adjusting airflow vertically manually.
Instructions for cleaning the air filter when the indicator appears.
Cleaning instructions for external parts and the remote control.
Steps to check when the unit is completely unresponsive.
Checks for issues when the system stops after normal operation.
Diagnosing insufficient cooling or heating performance.
Investigating unexpected unit start or stop events.
General| Category | Air Conditioner |
|---|---|
| Type | Floor Standing |
| Cooling Capacity | 10.0 kW |
| Heating Capacity | 11.2 kW |
| Energy Efficiency Ratio (EER) | 2.81 |
| Indoor Unit Dimensions (HxWxD) | 1850 x 600 x 270 mm |
| Power Supply | 220-240 V, 50 Hz |
| Refrigerant | R410A |
| Noise Level (Outdoor) | 52 dBA |
To Next Page
