EDUS391777-F17 Installation Manual
FXSQ-TAVJU 4
3P184443-13Z
4
English
Items to be checked In case of defective
Check
column
Are the sizes of electric
wiring according to the
URGEKƂECVKQP!
Does not operate ·
burnout
Are any of air outlets or inlets
of the indoor and outdoor
WPKVUDNQEMGFYKVJQDUVCENGU!
(It may lead to capacity drop
due to fan speed drop or
malfunction of equipment.)
Does not cool/
Does not heat
+UVJGGZVGTPCNUVCVKERTGU-
UWTGUGVEQTTGEVN[!
Does not cool/
Does not heat
Have you recorded the
refrigerant piping length
and the refrigerant charge
COQWPVCFFGF!
Refrigerant charge
amount is not clear
Make sure to recheck the items of “SAFETY CONSIDERATIONS”.
(2) Items to be checked at delivery
Items to be checked
Check
column
*CXG[QWECTTKGFQWVƂGNFUGVVKPI!KHPGEGUUCT[
#TGVJGEQPVTQNDQZNKFVJGCKTƂNVGTCPFVJGUWEVKQP
ITKNNGCVVCEJGF!
Does the cool air discharge during the cooling
operation and the warm air discharge during the
JGCVKPIQRGTCVKQP!&QGUVJGKPFQQTWPKVOCMGU
WPRNGCUCPVUQWPFQHCKTFKUEJCTIG!
*CXG[QWGZRNCKPGFJQYVQQRGTCVGVJGCKT
conditioner showing the operation manual to the
EWUVQOGT!
*CXG[QWGZRNCKPGFVJGFGUETKRVKQPQHEQQNKPI
heating, program dry and automatic (cooling/heat-
KPIIKXGPKPVJGQRGTCVKQPOCPWCNVQVJGEWUVQOGT!
If you set the fan speed at thermostat OFF, did you
GZRNCKPVJGUGVHCPURGGFVQVJGEWUVQOGT
Have you handed the operation manual and the
KPUVCNNCVKQPOCPWCNVQVJGEWUVQOGT!
Have you checked that there is no generation of
abnormal noise (i.e., noise resulting from contami-
PCVKQPQTOKUUKPIRCTVU!
Is the printed circuit board switch not on the emer-
IGPE['/)UKFG!
The switch is factory set to the normal (NORM.)
side.
If an optional accessory is in use, did you check the
QRGTCVKQPQHVJGQRVKQPCNCEEGUUQT[CPFOCMGƂGNF
UGVVKPIUCUPGGFGF!
+UVJGTGOQVGEQPVTQNNGTKEQPFKURNC[GF!+UVJGTG-
mote controller connected to the master unit if the
U[UVGOKUKPUKOWNVCPGQWUOWNVKQRGTCVKQP!
*CXG[QWGZRNCKPGFHCKNWTGGZCORNGUQH
3. SELECTION OF INSTALLATION LOCATION!
Points of the operation explanation
In addition to the general usage, since the items in the
operation manual with the
WARNING and
CAUTION marks are likely to result in human bodily
injuries and property damages, it is neces sary not only
to explain these items to the customer but also to have
the customer read them.
Furthermore, it is necessary to have the customer read
through the troubleshooting items while explaining the
above items.
3. SELECTION OF INSTALLATION
LOCATION
Hold the hangers at 4 locations to move the indoor unit
when unpacking or after unpacked, and do not apply force
VQVJGRKRKPITGHTKIGTCPVCPFFTCKPCPFCKTQWVNGVƃCPIG
If the temperature and humidity in the ceiling is likely to
exceed 30°C, RH80%, use the additional insulation stick
to the indoor unit.
Use the insulation such as glass wool or polyethylene
that has thickness of 10 mm or more. However, keep the
insulated outside dimension smaller than the ceiling
opening so that the unit may go through the opening at
installation.
(1) Select the installation location that meets the follow-
ing conditions and get approval of the cus tomer.
r Where the cool and warm air spreads evenly in the
room.
r Where there are no obstacles in the air passage.
r Where drainage can be ensured.
r Where the ceiling’s lower surface is not remarkably
inclined.
r 9JGTGVJGTGKUUWHƂEKGPVUVTGPIVJVQYKVJUVCPFVJG
YGKIJVQHVJGKPFQQTWPKV+HVJGUVTGPIVJKUKPUWHƂEKGPV
the indoor unit may vibrate and get in contact with the
ceiling and generate unpleasant chattering noise.)
r 9JGTGCURCEGUWHƂEKGPVHQTKPUVCNNCVKQPCPFUGTXKEG
can be ensured. (Refer to Fig. 1 and Fig. 2)
r Where the piping length between the indoor and the
outdoor units is ensured within the allowable length.
(Refer to the installation manual attached to the out-
door unit.)
r 9JGTGVJGTGKUPQTKUMQHƃCOOCDNGICUNGCM