Daikin FXSQ-TAVJU Series - ELECTRIC WIRING WORK

Installation Manual EDUS391777-F17
13 FXSQ-TAVJU
3P184443-13Z
13
English
8. DUCT WORK
Pay the utmost attention to the following items and con-
duct the ductwork.
r %JGEMVJCVVJGFWEVKUPQVKPGZEGUUQHVJGUGVVKPITCPIGQH
GZVGTPCNUVCVKERTGUUWTGHQTVJGWPKV4GHGTVQVJGVGEJPKECN
datasheet for the setting range.)
r Attach a canvas duct each to the air outlet and air inlet so
that the vibration of the equipment will not be transmitted to
the duct or ceiling.
Use a sound-absorbing material (insulation material) for the
lining of the duct and apply vibration insulation rubber to the
hanging bolts.
r At the time of duct welding, perform the curing of the duct
so that the sputter will not come in contact with the drain
RCPHQTVJGƂNVGT
r If the metal duct passes through a metal lath, wire lath, or
plate of a wooden structure, separate the duct and wall
electrically.
r Be sure to heat insulate the duct for the prevention of dew
condensation. (Material: Glass wool or styrene foam; Thick-
ness: 31/32 in. (25 mm))
r $GUWTGVQCVVCEJVJGƂGNFUWRRN[CKTƂNVGTVQVJGCKTKPNGVQH
VJGWPKVQTƂGNFUWRRN[KPNGVKPVJGCKTRCUUCIGQPVJGCKTUWE-
VKQPUKFG$GUWTGVQUGNGEVCPCKTƂNVGTYKVJCFWEVEQNNGEVKQP
GHƂEKGPE[QHYGKIJVRGTEGPV
r 'ZRNCKPVJGQRGTCVKQPCPFYCUJKPIOGVJQFUQHVJGNQECNN[
RTQEWTGFEQORQPGPVUKGVJGCKTƂNVGTCKTKPNGVITKNNGCPF
air outlet grille) to the customer.
r Locate the air outlet grille on the indoor side for the pre-
vention of drafts in a position where indirect contact with
people.
r The air conditioner incorporates a function to adjust the fan
to rated speed automatically. (10. FIELD SETTING)
Therefore, do not use booster fans midway in the duct.
Connection method of ducts on air inlet and outlet sides.
r %QPPGEVVJGƂGNFUWRRN[FWEVKPCNKIPOGPVYKVJVJGKPPGT
UKFGQHVJGƃCPIG
r
%QPPGEVVJGƃCPIGCPFWPKVYKVJVJGƃCPIGEQPPGEVKQPUETGY
(3).
r 9TCRCNWOKPWOVCRGCTQWPFVJGƃCPIGCPFFWEVLQKPVKP
order to prevent air leakage.
Unit
Insulation material
ƂGNFUWRRN[
%CPXCUFWEV
ƂGNFUWRRN[
(NCPIGQPCKTKPNGVUKFG
RTQXKFGFYKVJVJGWPKV
Insulation material
ƂGNFUWRRN[
Air inlet
Air outlet
5ETGYUHQTFWEV
ƃCPIGU
CEEGUUQT[
5ETGYU
HQTFWEV
ƃCPIGU
CEEGUUQT[
(NCPIGQPCKTQWVNGVUKFG
RTQXKFGFYKVJVJGWPKV
Fig. 20
CAUTION
%QPPGEVVJGƃCPIGCPFWPKVYKVJVJGƃCPIGEQPPGEVKQP
screw (3) regardless of whether the duct is connected to
the air inlet side.
9. ELECTRIC WIRING WORK
9-1 GENERAL INSTRUCTIONS
r Make certain that all electric wiring work is carried out by
SWCNKƂGFRGTUQPPGNCEEQTFKPIVQVJGCRRNKECDNGNGIKUNCVKQP
and this installation manual, using a separate dedicated
circuit.
+PUWHƂEKGPVECRCEKV[QHVJGRQYGTUWRRN[EKTEWKVQTKORTQRGT
GNGEVTKECNEQPUVTWEVKQPOC[NGCFVQGNGEVTKEUJQEMUQTCƂTG
r Make sure to install an ground leakage breaker.
(CKNWTGVQFQUQOC[ECWUGGNGEVTKEUJQEMUCPFCƂTG
r Do not turn on the power supply (branch switch, branch
QXGTEWTTGPVEKTEWKVDTGCMGTWPVKNCNNVJGYQTMUCTGƂPKUJGF
r Multiple number of indoor units are connected to one out-
door unit. Name each indoor unit as A-unit, B-unit ….. and
the like. When these indoor units are wired to the outdoor
unit and the Branch Selector unit, always wire the indoor
unit to the terminal indicated with the same symbol on the
terminal block. If the wiring and the piping are connected
to the different indoor units and operated, it will result in
malfunction.
r Make sure to ground the air conditioner.
Grounding resistance should be according to applicable
legislation.
r Do not connect the ground wiring to gas or water pipings,
lightning conductor or telephone ground wiring.
r Gas piping .................+IPKVKQPQTGZRNQUKQPOC[QEEWTKH
the gas leaks.
r Water piping ..............Hard vinyl tubes are not effective
grounds.
r Lightning conductor or telephone ground wiring .............
Electric potential may rise abnormally if struck by a light-
ning bolt.
r For electric wiring work, refer to also the “WIRING DIA-
)4#/qCVVCEJGFVQVJGEQPVTQNDQZNKF
r Carry out wiring between the outdoor units, indoor units
and the remote controllers according to the wiring diagram.
r Carry out installation and wiring of the remote controller ac-
cording to the “installation manual” attached to the remote
controller.
r Do not touch the Printed Circuit Board assembly. It may
cause malfunction.