REMOTE CONTROLLER LOSS PREVENTION WITH BALL CHAIN
(OPTIONAL)
Remote controller
Screw
Wall attachment screw
Holder
Ball chain (350mm)
iii
Installation
1. Match the ring at the end of the ball chain with the screw hole on the back of the remote
controller and secure it with the screw.
2. Attach the holder and the ball chain as above at the position where signals from the
remote controller can be received easily.
3. Pass the ball chain through the back of the holder and match the ring at the end of the
ball chain to the upper hole of the holder. Fix the holder to the wall by putting through
2 screws across it.
To Next Page
Loading...
