Daikin GS02 Remote Control - Operating Guide; Transmission Source; Signal Transmission Indication; ON;OFF Button

ENGLISH
1
OPERATING GUIDE
1. Transmission source
• The source where the signal will be transmitted.
2. Signal transmission indication
• Blink to conÞ rm that the last setting has been transmitted to the unit.
3. “ON/OFF” Button
• Press once to start the air conditioner unit.
• Press again to stop the unit.
4. Fan speed selection
• Pressing the
button continuously will toggle the fan speed in the following
order:
Low
Med High Auto
• Stop pressing when the desired fan speed appears on the display screen.
5. Operation mode
• Press the MODE button to select the type of operating mode.
• For cooling only unit, the available modes are: COOL (
), DRY ( ) and
FAN (
).
• For heat pump unit, the available modes are: AUTO ( ), COOL ( ), DRY ( ),
FAN (
) and HEAT ( ).
• The AUTO (
) mode is unavailable for chilled water system.
6. Automatic air swing
• Press the SWING
button to activate the automatic air swing function.
• To distribute the air to a speciÞ c direction, press the SWING
button and wait
until the louver move to the desired direction and press the button once again.
Swing mode selection method (for CK-E model)
• Press SWING ( ) button for 4 seconds to enter Þ eld setting mode. While in Þ eld
setting mode, it will only show SWING MODE (
).
• Press temperature
and button to select SWING MODE ( ) rotation from
Swing Mode 1 to Swing Mode 3.
• There are 3 different SWING MODE, which are:
Swing mode 1 Swing mode 2 Swing mode 3
SWING MODE will not activate unless SWING is activated.
Swing is indicated by the logo:
• If no mode changes within 4 seconds, unit will operate according to the selected
SWING MODE (
).
7. Turbo function (model dependent)
• Press for fast cooling or heating operation.
• Fan speed turn to maximum speed.
• Press again to deactivate the function.
• Available under HEAT and COOL modes only.
• Any change of fan speed will deactivate this function.
• The Turbo function (
) is unavailable for chilled water system and remote control
with SWING MODE ( ) function.
Original Instruction