Troubleshooting
Before consulting your dealer or asking for repairs, check the following points.
If the problems still can not be solved, consult your dealer.
The lamp lights up or blinks.
The airfl ow rate lamps blink
simultaneously.
The unit does not blow air.
Is there any obstacle in the air outlet? ●
Disconnect the power plug and remove the obstacle. Reconnect Î
the power plug and turn the power on.
If the present condition does not change or you can not remove
the obstacle, consult your dealer.
The “UNIT1” lamp or “UNIT2”
lamp does not go off or light
up again even after cleaning
UNIT1 or UNIT2.
Are UNIT1 and UNIT2 set correctly? ●
Insert UNIT1 until it clicks. Î
Insert UNIT2 completely to the end.
Page 17-20.
►
Are water drops, detergent, or bits of fi bre left in UNIT1 and ●
UNIT2 after cleaning?
After cleaning, wash UNIT1 and UNIT2 well so as not to leave Î
detergent or bits of fi bre, and completely dry them.
Are the ionised wires cut? ●
Check the ionised wires. Consult your dealer for replacement with Î
new ones.
The fi lter lamp does not go off,
although the pleated fi lter is
replaced.
Did you press the fi lter reset button for 5 seconds? ●
Even if the pleated fi lter is replaced, unless you press the fi lter Î
reset button for 5 seconds, the fi lter lamp does not go off.
Page 21.
►
Other
There is a burn mark on the
metal part of UNIT2.
This is a mark made by the streamer discharge and is not abnormal. ●
The TV picture is distorted.
Is a TV or radio installed within 2m of the unit or is an indoor ●
antenna used close to the unit?
Is the power supply cord or the antenna of the TV or radio close ●
to the unit?
Move the unit as far away from TVs, radios and antennas as Î
possible.
A sound is heard.
A crackling or buzzing sound
is heard during operation.
Are UNIT1 and UNIT2 correctly set? ●
Insert UNIT1 until it clicks. Î
Insert UNIT2 completely to the end.
Page 17-20.
►
Is dust adhered to UNIT1 and UNIT2? ●
Page 19, 20.
►
A fi zzing sound is heard
during operation.
UNIT2 makes a hissing sound caused by the streamer discharge ●
during operation.
Depending on the usage conditions, the sound becomes lower or the
sound quality may change, but this does not indicate any problem
with operation.
If the sound persists, change the installation site of the unit.
01_EN_3P276413-3C.indd 2501_EN_3P276413-3C.indd 25 9/27/2011 1:27:42 PM9/27/2011 1:27:42 PM
To Next Page
Loading...
Need help?
General
