Daikin MCB50YSAU - Page 9

8
English
Read First
Operations and operating status will be notied by tones.
• Operation start ... 2 quick beeps
• Setting change ... 1 short beep
• Operation end .... 1 long beep
• Filter replacement reset
...
2 short beeps
• When not usable
..............
3 short beeps
• Notication
.......................
3 long beeps
1
LOCK function lamp (orange)
The lamp will be lit when the LOCK function
is active.
Filter replacement lamp (orange)
Lights up approx. 1 month before the dust
collection lter needs to be replaced, and
blinks when it is time to replace the dust
collection lter.
MODE lamps (green)
Indicate the MODE in operation.
FAN lamps (green)
Indicate the active FAN setting
(4levels: Quiet, Low, Standard,
Turbo).
3
Odor sensor lamp
Indicates the intensity of odors in 3 colors: green, orange, red.
• Green indicates that the air is clean.
Green
Orange
Red
Low
High
Lamp
color
Odors
FAN/MODE button
Press to cycle between FAN
settings and AUTO MODEs.
► Page 12, 13
UV ON/OFF lamp (Blue)
Lights up when UV rays are emitted.
ON/OFF button
Press to turn the power ON, press
again to turn OFF.
► Page 12
Operating/Indicator panel
UV ON/OFF button
UV rays are emitted.
► Page 12
BRIGHTNESS button
Each press changes the lamp
that is lit, and cycles through
indicator lamp brightness levels.
► Page 13
2
Dust/Particle sensor lamp
Indicates the volume of dust in 3 colors: green, orange, red.
• Green indicates that the air is clean.
Green Orange Red
Low
High
Lamp
color
Dust
• The dust/particle sensor can detect large dust (approx. 2.5μm
and above) and small particles (approx. 1.0-2.5μm). The particle
lamp lights in response to small particles and the dust lamp lights
in response to large dust particles.
01_EN_3P671617-2A.indd 8 2021/11/22 16:27:33