Daikin Perfera FTXM-A Series - Page 14

5 Operation
Operation manual
14
FTXM60~71A2V1B
Daikin room air conditioner
3P728539-5F – 2024.01
INFORMATION
Make sure operation is stopped before setting the wireless
connection. Connection CANNOT be made when the unit
is in operation.
1 Stop operation before setting the wireless connection.
2 Make sure the wireless router is close enough to the unit and
nothing obstructs the signal.
Menu Description
Connection status check
Connection using WPS button
Connection using SSID and KEY
Reset to factory default
Wireless LAN OFF
To confirm the wireless LAN connection status
1 On home screen menu, press and hold for at least
5seconds while the unit is not operating.
Result: The SP (wireless connection setting menu) appears.
is blinking.
(5 sec.)
2 Press to confirm the selection.
Result: is blinking.
3 Check the Daikin eye.
b
c
a
a Daikin eye
b Partly green
c Red, orange or blue
Daikin eye colour alternates
between partly green and…
…then wireless adapter is…
Red not connected
orange running and ready to connect to
the home network via WPS
button; see "To connect using
the WPS button"[414].
blue connected to the home network:
▪ via SSID + KEY.
or
▪ via the WPS button on the
router.
4 Press to exit the menu.
Result: The display will return to the default screen.
To connect the wireless LAN to your home
network
The wireless adapter can be connected to your home network using
the:
▪ WPS button (Wi-Fi Protected Setup) on the router (if present),
▪ The SSID (Service Set Identifier) and the KEY (password) -
located on the unit.
To connect using the WPS button
1 On home screen menu, hold for at least 5 seconds while
the unit is not operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu by pressing once or
repeatedly.
1×
(5 sec.)
3 Press to confirm the selection.
Result: is blinking. The Daikin eye colour alternates between
orange and partly green.
4 Press the WPS button on your communication device (e.g.
router) within approximately 1 minute. Refer to the manual of
your communication device.
Result: The Daikin eye colour alternates between blue and
partly green.
INFORMATION
If the connection with your router is not possible, try
procedure "To connect using SSID and KEY
number"[414].
5 Press to exit the menu.
Result: The display will return to the default screen.
To connect using SSID and KEY number
1 On home screen menu, hold for at least 5 seconds while
the unit is not operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu by pressing twice or
repeatedly.
2×
(5 sec.)
3 Press to confirm the selection.
Result: is blinking. The Daikin eye colour alternates between
red and partly green.
4 Open the ONECTA application on your smart device and follow
the steps on the screen.
Result: If the connection was successful, the Daikin eye colour
alternates between blue and partly green.
5 Press to exit the menu.
Result: The display will return to the default screen.