EasyManua.ls Logo

Daikin R24NUV2S User Manual

Daikin R24NUV2S
501 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Pocket
Manual
Service Diagnosis
Si20 - 701_B

Table of Contents

Other manuals for Daikin R24NUV2S

Question and Answer IconNeed help?

Do you have a question about the Daikin R24NUV2S and is the answer not in the manual?

Daikin R24NUV2S Specifications

General IconGeneral
Cooling Capacity2.4 kW
Energy Efficiency Ratio (Cooling)3.21
RefrigerantR32
Voltage (V)220-240V
TypeSplit Air Conditioner
Energy Efficiency Rating5 Stars
Power Supply220-240V, 50Hz
Noise Level (Indoor Unit)19 dB
Indoor Unit Dimensions (W x H x D)223 mm
Outdoor Unit Dimensions (W x H x D)780 x 550 x 285 mm

Summary

Symptom-based Troubleshooting

2.2 Equipment does not Operate

Addresses troubleshooting steps when the equipment fails to start or operate.

2.3 Indoor Unit Fan Operates, but Compressor does not Operate

Troubleshoots scenarios where only the indoor fan is running, but the compressor is inactive.

2.4 Cooling / Heating Operation Starts but Stops Immediately

Provides solutions for systems that start and then stop operation shortly after.

Troubleshooting by Remote Controller

3.1 Procedure of Self-diagnosis by Remote Controller

Details the steps for performing self-diagnosis using the remote controller.

3.2 Error Codes and Description

Lists and describes various error codes for indoor and outdoor units.

3.3 Detailed Error Codes

Provides detailed explanations and diagnostic steps for specific error codes.

3.4 A0 Error of External Protection Device

Addresses troubleshooting for error code A0 related to external protection devices.

3.6 A3 Drain Water Level System Abnormality

Details troubleshooting for error code A3 related to the drain water level system.

3.7 A6 Indoor Unit Fan Motor Abnormality

Provides solutions for error code A6 indicating an indoor unit fan motor abnormality.

3.14 AJ Capacity Setting Abnormality

Troubleshoots error code AJ related to incorrect capacity settings.

3.21 E0 Actuation of Safety Device

Outlines steps for resolving error code E0 related to safety device actuation.

3.24 E3 High Pressure System Abnormality

Provides troubleshooting for error code E3 concerning high pressure system abnormalities.

Related product manuals