Why is my Daikin RKH25CVMB9 outdoor unit leaking water?
In HEAT mode, the frost on the outdoor unit melts into water or steam during defrost operation. In COOL or DRY mode, moisture in the air condenses into water on the cool surface of the outdoor unit piping and drips.
Why does my Daikin RKH25CVMB9 Air Conditioner smell?
The Daikin Air Conditioner may emit odors because smells from the room, furniture, or cigarettes have been absorbed into the unit and are being discharged with the airflow. It is recommended to have the indoor unit cleaned by a technician. Consult the service shop where you bought the air conditioner.
What to do if my Daikin Air Conditioner heating stops suddenly?
The system is likely removing frost from the outdoor unit. You should wait for about 3 to 8 minutes.
Why doesn't hot air come out immediately from my Daikin RKH25CVMB9 when heating?
You should wait for 1 to 4 minutes. The system is designed to start discharging air only after it has reached a certain temperature.
Why my Daikin Air Conditioner does not start immediately?
If the ON/OFF button was pressed soon after operation was stopped, or if the mode was reselected, you should wait for about 3 minutes.
What to do if my Daikin RKH25CVMB9 Air Conditioner operation stopped suddenly?
For system protection, the air conditioner may stop operating due to a sudden large voltage fluctuation. It will automatically resume operation in about 3 minutes.
Why is the Daikin Air Conditioner outdoor fan running when it's off?
After operation is stopped, the outdoor fan may continue rotating for another 60 seconds for system protection. Also, when the outdoor temperature is very high, the outdoor fan might start rotating for system protection even when the air conditioner is not in operation.
Why does mist come out of my Daikin RKH25CVMB9?
This happens when the air in the room is cooled into mist by the cold air flow during cooling operation.
General safety warnings, pictograms, and precautions for handling the equipment.
Details functions and features for high-grade models.
Details functions and features for standard-grade models.
Details functions and features for non-inverter models.
Technical specifications for cooling-only air conditioner models.
Technical specifications for heat pump air conditioner models.
Explains the inverter's frequency control for compressor operation.
Details compressor frequency determination and control logic.
Details the freeze-up protection during cooling operation.
Explains the defrost control procedure for heat pump models.
Details the control logic for the electronic expansion valve.
Covers sensor malfunction and overload/overcurrent detection.
Essential safety warnings and cautions for installation and operation.
Lists common non-trouble cases and handling.
Warnings and guidelines for safe diagnostic procedures.
Lists common symptoms and initial troubleshooting steps.
Lists system error codes and their meanings.
Troubleshooting for freeze-up or high-pressure conditions.
Guides on troubleshooting communication errors between units.
Explains troubleshooting for compressor overload.
Details troubleshooting steps for compressor lock issues.
Guides on troubleshooting high pressure in cooling mode.
Details troubleshooting for electrical box temperature rise.
Details troubleshooting steps for insufficient gas conditions.
Explains troubleshooting for over-voltage detection.
Details the procedure for removing the compressor.
General| Cooling Capacity | 2.5 kW |
|---|---|
| Heating Capacity | 3.2 kW |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Indoor Unit Dimensions (WxHxD) | 770x285x223 mm |
| Indoor Unit Weight | 8.5 kg |
To Next Page
