RA Indoor Unit SiBE121021_C
156 Operation Manual
îš„
Indoor Unit
Model
Mode
COOL
22ËšC AUTO
AUTO
25ËšC
AUTO
Temperature
setting
Airflow
rate
COOLING
ONLY
HEAT
PUMP
1. Air filter
2. Titanium Apatite Photocatalytic
Air-Purifying Filter:
• These filters are attached to the inside of
the air filters.
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the
unit.
7. INTELLIGENT EYE sensor
8. Display
9. Air outlet
10. Horizontal blades (flaps)
11. Vertical blades (louvers):
• The louvers are inside of the air outlet.
12. Indoor Unit ON/OFF switch
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.
• This switch is useful when the remote
controller is missing.
13. Operation lamp (green)
14. TIMER lamp (yellow)
15.
INTELLIGENT EYE lamp (green)
16. Signal receiver:
•
It receives signals from the remote controller.
• When the unit receives a signal, you will
hear a short beep.
• Operation start ........beep-beep
• Settings changed.....beep
• Operation stop..........beeeeep
To Next Page
Loading...
Need help?
General
