SiBE121021_C RA Indoor Unit
Operation Manual 159
îš„ Indoor Unit
Model Mode
COOL 22ËšC AUTO
AUTO 25ËšC AUTO
COOLING
ONLY
HEAT
PUMP
Temperature
setting
Airflow
rate
1. Air filter
2. Titanium apatite photocatalytic
air-purifying filter:
•These filters are attached to the inside of
the air filters.
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the
unit.
7. INTELLIGENT EYE sensor
8. Display
9. Air outlet
10. Flaps (horizontal blades)
11. Louvers (vertical blades):
• The louvers are inside of the air outlet.
12. Model name plate
13. Indoor unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refers to the following
table.
• This switch is useful when the remote
controller is missing.
14. OPERATION lamp (green)
15. TIMER lamp (yellow)
16.
INTELLIGENT EYE lamp (green)
17. Signal receiver:
•
It receives signals from the remote controller.
• When the unit receives a signal, you will
hear a beep sound.
• Operation start ..........beep-beep
• Settings changed.......beep
• Operation stop...........long beep
To Next Page
Loading...
Need help?
General
