Need help?Do you have a question about the Daikin WSC087 and is the answer not in the manual?
Procedures for inspecting and handling Daikin centrifugal water chillers upon receipt.
Guidelines for mounting the chiller on a level base and required service clearances.
Details on Victaulic connections, flange connections, and piping considerations.
Step-by-step instructions for installing Victaulic couplings.
Importance and installation of water flow switches for safety and operation.
Description of evaporator insulation and compliance standards.
Information on condenser design, relief protection, and physical data.
Table detailing physical data and weights for single compressor units (WSC).
Table detailing physical data and weights for dual compressor units (WDC/WCC).
Procedures for insulating motor terminals for voltages 600 volts or greater.
Step-by-step instructions for installing the motor terminal box.
Field wiring requirements for transmitting motor information to the chiller control panel.
Purpose and wiring of water flow interlocks for evaporator and condenser pumps.
Specific wiring instructions for connecting chillers via pLAN and isolation boards.
Overview of the MicroTech II control system components.
Guidelines for servicing the lubrication system and oil analysis.
Step-by-step guide for charging the refrigerant system.
Guidelines for interpreting oil wear test results and handling polyolester oils.
To Next Page
General
