DAITEM SH710AX - Preparation; Power supply

GB
140
2. Preparation
2.1 Tooling required 2.2 Power supply
IMPORTANT: the fixing screws and
plugs are not supplied.
8 mm
PZ 2
3.5 mm
1. Loosen the 4 cover screws
and open the receiver.
Coller sur certif
SH710AX
A1250A04823
SH710AX
A1250A04823
Coller sur certif
SH710AX
A1250A04823
SH710AX
A1250A04823
2. Remove the pre-cut part of the
sticker and stick it to the
guarantee certificate in the user
manual supplied with the control
panel. If you are adding to an
existing system, use the
guarantee sticker provided with
this product.