Daktronics DMP-5000 Series - Sign Configuration

Cong
15
Signs
The Signs section lists any sign(s) associated with an output and show conguration
details such as Dimensions and Mode. All congured signs are also shown in the left-side
menu (e.g. primary in Figure 23).
Figure 23: Add Sign
Click Add Sign to add a new sign to an output. A new sign is automatically added with
a generic name such as Sign 1. This new sign is listed in the signs section and under the
output name in the left-side menu in red with a red exclamation point. Refer to Figure 24.
Figure 24: Conguration - Output
The new sign must be congured before it can be saved to the DMP. Refer to Sign
Conguration(p.17).