| 31
Follow the following instructions with the help of the scheme in Pic.1.
• Turn on the water tap (
1
Pic.1).
• Turn on the ON/OFF electric supply switch (
7
Pic.1) and turn the machine switch clockwise (
1
Pic.2);
make sure the power light ( Pic.3) comes on.
• As soon as the machine has been turned on, the automatic auto-fill function starts filling the boiler
until the right level is reached; during this stage, the light (Pic.3) comes on.
• Once the filling phase is over, the brewing group will start heating up and the light will start blinking.
• At the end of the heating stage, the light will stop blinking.
• Immediately afterwards, the boiler starts to heat up and the light starts blinking. Once the pre-set
temperature has been reached, the light will stop blinking.
• The brewing group can be used while boiler is still heating up.
Multi-function dial knob
By rotating the multi-function dial knob (M Pic.3) you can choose the desired functions, and therefore
every position of the dial knob will switch on one of the six lights ( to - if active).
Functions in this manual will be referred to as - .
Starting
and using the machine
NOTE
This heating sequence takes place
only when the machine is switched
on after it has been switched off
completely with the main switch
(
1
Pic.2).
This sequence allows the machine
to heat up without using too much
energy, thus avoiding possible
overload troubles in the local power
system.
To Next Page
Loading...
