Danby DGR546W - Alignments and Adjustments

ALIGNMENTS AND ADJUSTMENTS
Installation
tl is the respousibility of the i_sta]ter to make ee_in that the range, is properly adjusted
at the time of installation. Situalions caused by imlPml_r adjustments or improper
installation are. not covered under the warranty. Any expenses incurred due to such
situations will not be paid by the manufacturer o1"the appliartce.
Gas Range Conversion and Adjustment Guide
The range will either be set for L=sewith Liquefied Petroleum (LP) or Natulal Gas. The
facto O, setting is indicated on the serial plate, When set for Natural Gas operation, file
pressure regulator will regulate the pressure to 4 inches water column. When set for LP
Gas o_pemtion, the pressure regulator will regulate the gas to 10 inches water column
p_ssure.
"lo Convert and/or Adjust
1, Convertible Pressure rRegulator
The tale( pressure of the gas supply shall be [n accordance with the nominal inlet
pressure of the regulator used oft the rang_ or I/2 psig maximum. The range should he
tested by pressurizing the t_gulator with an inlet pressure at least t inch water column
above the manufactuzeds specified manifold pressure shown on the serial plate,. The
range wiU be equipped with one of the two types of regulators shown.
For a Harper-Wyman
regulalor, remove
converter cap by inserting
a coin into slot in top and
twisting, Turn cap over
and re-instalL
On the SCP regulator.
unscrew file converter
using a 5/8" wrench, Turn
the cap over and reinstall,
LPG_
('t_'_,. _ Harper-Wyman
\_7 Regulator
LPG@ _ N'AT
Note: What you read on the converter cap or plunger is thetype of gas for which the regulator
is set, If yours reads NAT, the regulator is set for" natural gas. tf yours reads LP, th_ regulator
]s set for LP,
12