ALIGNMENTS AND ADJUSTMENTS, Continued
IF THE OVEN BURNER DOES NO]" IGNITE WITHIN 20 TO 60
SECONDS AFTER THE PILOT IS LIGHTED, TURN THE OVEN
TEMPERATURE CONTROL TO OFF AND WAlT FOR POWER TO BE
RESTORED, DO N(Yl" ATTEMPTTO RELIGHT THE PILOTAGAtN.
If the oven does not function properly when the power is re_tored, or at any oflter lime,
call a serviceman to determine the source of the problem, DO NOT ATTEMPT TO
SERVICE THE RANGE YOURSELE
5, A.ul_matic Oven Safely Valve
The orifice hood on the oven safety valve regulates file flow of gas to the oven burner.
This valve adjusts in The same manlier as the top burner valves and is located at the base
of the oven burner in the broiler compartment of the range. To gain access, simply
remove the bioitez section. When set for LP, the orifice hood is scmveed snugly on lhe
valve. To adjust for use on Natural Gas, unscrew the orifice hood until the proper flow
of gas is obtained.
6, Oven Burner Air Shutter Adjustment
The oven btlrner flame should be a clean, blue flame with distinct inner cones
approximately It2 inch long. A soft, lazy flame ',_dth ]udistinct comes mean_ too much
g_ or not enough air. A noisy lifting flam_ means too much Mc tf adjustments am
ue..cesmry you must first loosen the lock screw located at the top ofthe _fi_shutter, then
rotate the air shutter to the correct setting, and retighten screw,
OVENBURNER
LOCKSCREW.
_MR_HiJr_ER N k
OVE N SAFETY VALVE
1/2" CONE
______J
OVEN BURNER
Oven burneI flame can be checked as follows (without burner baffle in place):
, To cermet a yellow flame-Increase size of air _hutter opening.
, To correct a lifting, but distinct, biue flame-Decrease size of air shutter opening,
The air shutter should be set approximntely 2/.3 open for naluraJ gas, and approximately
ful!l open on LP gas.
The oven burner ai r shutter adjustmem is the same on ran_ with agas pilot or elecldc ignition.
17
To Next Page
Loading...
