Problem Possible Causes What To Do
Sputtering draw
Faucet Dripping
Rapid C0
2
cylinder
discharge
Difficulty
Manipulating Faucet
handle
Abnormal beer
taste and/or smell
Dispense system
requires cleaning.
Keg Coupler installed
incorrectly
Line or dispenser
obstructions.
Improper draw technique
Handle not fully returned
to close position.
Faucet requires cleaning.
Improper connection, air
line leak.
Faucet requires cleaning
Damaged handle stem
Dispense system
requires cleaning.
Contaminated dispense
system.
The beer has exceeded
it’s shelf-life.
See “Cleaning and Maintenance” on pg. 17-18
Check seal between keg & faucet
Verify that there are no ‘kinks’ or obstructions in either
the air line (red) or dispenser line (clear) and that
neither are frozen.
see “Using Proper Draw Technique” on pg. 16.
After every pour, ensure the handle is returned to the
the off position.
See “Cleaning and Maintenance” on pg. 17-18
Ensure proper connection of air line at CO2 regulator,
and/or check air line for possible leaks
See “Cleaning and Maintenance” on pg. 17-18
Remove handle, and connector nuts and inspect stem
for possible damage.
See “Cleaning and Maintenance” on pg. 17-18
Check hoses for possible air leaks. Ensure all
connections are secure and all seals are in place and
in good condition.
Replace Beer Keg.
TROUBLESHOOTING (Cont’d)
BEFORE YOU CALL FOR SERVICE
20
To Next Page
Loading...
