To Next PageTo Next Page
Need help?Do you have a question about the Dancing Wings Hobby Sunbird and is the answer not in the manual?
General| Brand | Dancing Wings Hobby |
|---|---|
| Model | Sunbird |
| Category | Toy |
| Language | English |
Paste together F1 and F2, then fasten the joint with F3.
Cut balsa strips to length and assemble them in place on the fuselage.
Paste together F5 and F6, then fasten the joint with F7.
Paste the finished board to the bottom of the fuselage.
Assemble the cabin cover as shown in the picture.
Paste covers F4 and F8, and the servo mount base F16.
Assemble the tail per the 1:1 plan, ensuring straightness.
Attach vertical/horizontal tail to fuselage, connect ailerons with U-shape wire.
Assemble the wing as per the 1:1 plan, ensuring straightness.
Paste the balsa cover onto the wing and polish.
Assemble connection part W20 and glue the two wing parts together.
Cut balsa strips to length and assemble them in place on the wing.
Assemble left and right wings, connecting them with carbon tubes.
Paste F17 and F18 together, and assemble the nut onto F18.
Assemble the wing onto the fuselage, drilling and fastening with a screw.
Assemble and install the motor, ESC, battery, and servos as shown.
