Need help?Do you have a question about the d&b audiotechnik M4 and is the answer not in the manual?
General| Configuration | 2-way |
|---|---|
| Components | 1 x 12" woofer, 1 x 1.4" compression driver |
| Power Handling (peak) | 1600 W |
| Nominal Impedance | 8 ohms |
| Enclosure Material | Birch plywood |
| Finish | Black textured paint |
| Type | Stage Monitor |
| Power Handling | 400 W |
| Grille | Steel grille with foam |
| Connectors | 2 x Speakon |
Guidelines for safe operation and placement of loudspeakers to prevent accidents and hearing damage.
Details on the M4's EP5 and optional NL4 connectors and their pin assignments.
Guidance on passively driving up to two M4 loudspeakers with a d&b D6 amplifier.
Configuration for active 2-way operation, routing separate LF and HF signals to M4 cabinets.
Configuration for passive operation where each channel drives LF and HF via the crossover.
Information on using M4 in Mix TOP/SUB mode with specific cabling requirements.
Setting to reduce low frequencies for use with subwoofers.
High-Frequency Attenuation to balance response for near-field listening.
Compensates for coupling effects in arrays or boosts low frequencies for PA use.
Using the E-PAC to drive M4 loudspeakers with CUT and HFA adjustments.
Instructions on rotating the horn assembly for installation using specific tools and torque.
Frequency response and maximum sound pressure levels for passive and active modes.
Details on impedance, power handling, components, and connections for the M4 loudspeaker.
Physical dimensions of the M4 cabinet in millimeters and inches.
Declaration of conformity with relevant EC directives for the M4 loudspeaker.
Guidelines for the proper disposal of the M4 loudspeaker as electronic equipment.
To Next Page
