D&D Technologies LokkLatch Magnetic User Manual

1
2
3
5
Hi-Performance Hardware
Installation Instructions
#
2
#
2
I
4
8
7
8
1
2
3
4
Ensure housing is in vertical
position before fitting the Push Rod.
III
1
/2” (13mm)
*
3
/
8
”–1
1
/
4
” (
10mm–32mm
)
#
2
II
3
/16” (5mm)
*
#
1
Note
I
II
III
IV
1
2
3
4
#
1
IV
Groove
Surco
Cannelure
I
II
*
5
/32” (4mm)
5
/32” (4mm)
1
/2” (13mm)
3
1
/2” (90mm)
File
Lima
Lime
6
Use file to ensure push rod is square
and does not extend beyond post more
than
3
/16” (5mm).
3
/16” (5mm).
FIT THE TRIM COVERS
G
A
P
V
A
R
I
A
N
C
E
G
A
T
E
F
R
A
M
E
Trim covers cannot be removed once fitted.
INSERT PUSH ROD FIRMLY INTO HOUSING UNTIL GROOVE IS ALIGNED WITH HOUSING
Not suitable for child safety gates - Use MagnaLatch instead.
DRILL PUSH-ROD THROUGH-HOLE INTO GATE
Front
Back
Fitting Jig
Refer to B on back page
Ensure hole through gate is level
Refer to A on back page
FASTEN LATCH TO GATE
SAW PUSH-ROD FLUSH WITH FITTING JIG
Fitting Jig
Do NOT cut push-rod at an angle
Gate Post
ALIGN AND FASTEN THE EAK
INSTALLING EXTERNAL ACCESS KIT (EAK)
Firmly tighten screws on all components.
INSERT DRESS CAPS
File

D&D Technologies LokkLatch Magnetic Specifications

General

Finish	Black
Latch Type	Magnetic
Keyless	Yes
Installation	Surface Mount
Lockable	Yes
Vertical Adjustment	Yes
Weather Resistance	Yes
Material	Stainless Steel
Gate Gap	1/2" to 1 1/2"
Operation	Pull to open
Type	Latch
Suitable For	Gates

Summary

LOKK Latch Magnetic Installation

Gap Variance and Preparation

Specifies gap variance and notes on child safety gates.

Trim Cover and Push Rod Assembly

Instructions for fitting trim covers, inserting push rod, and drilling holes.

Latch Fastening and Push Rod Trimming

Guides on fastening the latch, sawing the push-rod flush, and fitting jig use.

External Access Kit (EAK) Installation

Steps for installing the EAK, aligning it, and inserting dress caps.

LOKK Latch Magnetic Keeper and Alignment

Keeper Installation and Vertical Alignment

Instructions for marking, installing, and checking vertical alignment of the keeper.

Horizontal Alignment and Component Joining

Steps for checking horizontal alignment and joining latch components securely.

Removing and Replacing Screw Covers

Procedure for removing and replacing screw covers on the latch mechanism.

Maintenance Recommendations

Guidelines for maintaining the latch, including cleaning and lubrication advice.