8
6.3 Installation
There are three variants to connect the decoder:
1 In case your locomotive is equipped with an interface (NEM 651), you should take the decoder
DH05A/B-1, DH10A/B-1 respectively FH05A-1. They have already the appropriate connections for this
plug. Shorten the ribbon cable up to approximately 5 mm and remove the rest of the insulation. The
decoder can be inserted into the interface without any problem now.
2 If the locomotive is not equipped with an interface jack, the decoder must be wired up individually. For
this purpose you should use decoder with flexible wires (DH05A/B-3, DH10A/B-3 respectively
FH05A-3).
3 The decoder DH05A/B-0, DH10A/B-0 respectively FH05A-0 should be used by experienced model
railroaders only as the connection wires must be soldered directly onto the decoder.
To Next Page
Loading...
