I nstructions:
- Remove LCP panel from the AKD 102
- Remove the frame located beneath and discard
- Push the option into place. Two positions are possible, with cable terminal facing either up or down
- Push the fieldbus option adaptor frame for the AKD 102 into place
- Replace the LCP and attach cable
- On A1 and A2 enclosures with cable terminal facing up: Fasten the cable onto the de-coupling plate (the AKD 102 top surface has pre-drilled
threaded holes for attaching the de-coupling plate to the unit).
Please not e, for connection of screen, please refer to the graphic in section 4.1.1
The LonWorks Option
.
6. How to I nstall Option in Frequency Con-
verter ADAP-KOOL
®
AKD-LonWorks
16
MG.11.P1.02
6
To Previous Page
Loading...
