AK-PC 560 Manual RS8GE202 © Danfoss 01-2016 21
Override
The controller contains a number of functions that can be used to-
gether with the override function in the master gateway. They can
therefore only be used in combination with data communication.
Function via data communication
Functions to be used in the system units
override function
Selection of parameter in AK-PC 560
084B8013 Sw. 1.0x
Stop of injection when the compressor is
stopped
Forced Close / Injection ON / AKC ON
- - - MC Inject ON
Night setback Day/night control and time schedule
r27 NightSetback
Suction pressure optimisation P0 optimisation
Select controller address
(The parameters are found automatically and
do not become visible).
The system unit registers the refrigeration point which handles the largest capacity (requires the
lowest suction pressure). The parameter may be logged for use in a service situation.
- - - MLC
To Next Page
Loading...
Need help?
General
