Danfoss CP715 Si User Manual

9
Table B (pages 12-15) should be used. If in any doubt, contact
our Technical Services Department before proceeding with the
replacement. *Any wires connected to switch COMMONS which
are linked LIVE on existing wallplates must be transferred to the
LIVE terminal on the new wallplate
.
HTG
ON
Wires other
than links in
these terms
go to LIVE
NOTE
This conversion applies
only if....
An additional terminal
block may be required
where these discon-
nected leads (or pairs)
should be terminated
4LL ABCD
625
Programmed
selectors UNLINKED
21-
425
7-- 8
7 5 8 Terminals 5,8 & 10 are LINKED
6 5 7 Terminals 5 & 7 are LINKED
425
Programme
selectors UNLINKED
425
Programme
selectors UNLINKED
385
4--
53- SS
4-5
Programme
selectors UNLINKED
ABCD
4--
2--
165
83-
5--
Wiring Conversions

Danfoss CP715 Si Specifications

General

Brand	Danfoss
Model	CP715 Si
Category	Temperature Controller
Language	English