19
Press DAY/HOL to display day and
month. Use the + or - buttons to set
the correct month (Jan = 1, Feb = 2
etc.).
Press DAY/HOL to display day and
month. Use the + or - buttons to set
day of month.
Press PROG to display the time.
The words SET TIME will appear at
the top of the display & the time will
fl ash on and off .
Use the + or - buttons to set the
correct time (press and hold to
change in 10 min. increments).
Setting the Day
The day of the week is set automatically.
Accepting the preset programmes
If you are happy to use the preset
programmes on page 17, you don’t
need to do anything else.
To accept the factory presets just press the PROG button once
until the time appears & colon in the display begins to fl ash.
Your unit is now in RUN mode and will control your heating and
hot water according to the preset programmes.
Setting Day, Accepting Preset Programmes
7
To Next Page
Loading...
Need help?
General
