Danfoss FP715

25
+1HR
MAN
+1HR
MAN
The grey buttons next to the radiator symbol
are the Heating override buttons
The grey buttons next to the tap symbol are
the Hot Water override buttons
+1HR = pressing this button when either system is in
AUTO or ALLDAY mode will cause the heating/hot
water to remain on for an extra hour. If it is pressed
while the programme is OFF the heating/hot water
will come on immediately for 1 hour then go off
again.
MAN = pressing this button when either system is in
AUTO or ALLDAY mode will cause the heating/hot
water to go OFF until the next programmed ON, or
vice versa.
Temporary override buttons
Override buttons
Sometimes you may need to change the way you use
your heating temporarily, i.e. due to unusually cold
weather. The FP715 has two convenient overrides which
can be selected without affecting the set programme.
+1HR
MAN
+1HR
MAN