Danfoss ICM - Page 6

ICM/ICAD Motorized Valve Installation, Programming, and Troubleshooting
6 DKRCI.EI.HT0.A1.22 / 520H1639   Danfoss (USCO / MKS), 11- 2006
24 V d.c
Power
Supply
CUSTOMER SUPPLIED
Brown
Green
Gray
Yellow
PLC
Blue
Active 4-20 mA PLC output to control ICAD
Active 4-20 mA PLC output to control ICAD
Passive 4-20 mA PLC input
for valve position feedback
Passive 4-20 mA PLC input
for valve position feedback
White
Optional UPS/battery back up
+
+
+
-
-
+
-
Wiring diagram showing ICAD wired with
a PLC or other type of third-party
electronics
Note:
The ICAD supplies the power for the 4-20 mA
feedback signal.
Wiring diagram with Danfoss EKC
controllers
Note:
For instructions on completely wiring an EKC
controller, please see the relevant EKC
controller manual.
Terminal box is customer supplied.
Yellow (ground)
Gray
Blue (+ 4-20 mA)
Brown
Green
Optional position
feedback
Only possible
with EKC 347
24 V d.c
Power
Supply
(+ 4-20 mA)
White
+
-
Optional UPS/battery back up
+
CUSTOMER SUPPLIED
Terminal box is customer supplied.