Danfoss Link HP-kit - Quick Installation Guide for Danfoss Link HP Kit

3
VIIFR102 © Danfoss 03/2014
Installation manual Danfoss Link™ HP kit
Quick Installation Guide
^
^
^
^
+
-
+
-
21
3
4
Note the following when installing the Danfoss Link™ HP kit:
• Installation and positioning must be done in accordance with applicable laws and regulations.
• The Danfoss Link™ HP kit only works in conjunction with heat pumps DHP-H/L/A 2009 or later, using soft-
ware version 1.34 or later, and DHP-AQ with software version 2.2 or later. The Danfoss Link
™ HP kit is not
suitable for heat pumps with a cooling function (DHP-C and heat pumps with a cooling module).
Tip!
• The
?
key on the Danfoss Link™ CC panel can be used at any time during installation.
• Always check for the latest software version at www.link.danfoss.com before installation. See the section on software
upgrades in the Danfoss Link™ CC Installation Manual.
Install all mains powered units
rst and add them to the network
Create rooms and add battery-powered
units one at a time
Perform the network test with the Dan-
foss Link ™ CC is in its nal location
Install the components of
the Danfoss Link™ HP kit
“OK”