Danfoss Link HP-kit User Manual

9
VIIFR102 © Danfoss 03/2014
Installation manual Danfoss Link™ HP kit
Safety instructions
C Installation must be carried out in accordance with applicable laws and regulations, as well as
these instructions.
C The cables are live and may cause fatal electrical shock. The heat pump power supply must be
switched off before commencing electrical installation.
Software version
1. Check the software version on the DHP-AQ control
display. Press the left arrow on the heating pump
control until the display changes to “Service menu”.
2. Press “minus” until the cursor reaches the “Version”
menu.
3. Press the “right arrow”. This will bring up the
software version in the display. Link
™ for DHP-AQ
requires a softwareversion of 2.2 or newer.
≥ 2.2
Service menu
- Installation
- Version
+
_
< >
Location
The power supply must be mounted inside the heat pump control in the prepared holes in the electrical
panel. The DCM03 device is designed to be mounted on a wall as close as possible to the heat pump. The
distance is limited by the length of the DCM03 connection cable.
Installing the power supply
1. Switch off the power to the heat pump.
C Read the safety instructions before connect-
ing any wiring.

Danfoss Link HP-kit Specifications

General

Brand	Danfoss
Model	Link HP-kit
Category	Conference System
Language	English