Danfoss MCD 202

MCD Soft Starter Remote Operator
MG.17.E2.02 – VLT is a registered Danfoss trademark 1
Contents
■ Contents
■ Introduction
Important User Information .............................................................................. 2
General Description ......................................................................................... 2
Manual Description .......................................................................................... 2
■
Installation
Installation ....................................................................................................... 3
Mounting ........................................................................................................... 3
Connection ...................................................................................................... 3
■
Specifications
General Technical Data .................................................................................... 5
Dimensions ...................................................................................................... 5
■
Operation
Functionality Range .......................................................................................... 6
Operation ......................................................................................................... 6
Trip Codes ....................................................................................................... 6
■
4-20 mA Analogue Output
Overview .......................................................................................................... 8
Calibration ....................................................................................................... 8
Programming ................................................................................................... 8
■
Fault Description
General Faults .................................................................................................. 9

Danfoss MCD 202 Specifications

General

Brand	Danfoss
Model	MCD 202
Category	Controller
Language	English

Summary

Introduction

Important User Information

Essential safety precautions and guidelines for operating the soft starter remotely.

Installation

Mounting

Instructions for mounting the Remote Operator, including panel cutout and gasket seal.

Connection

Operation

Trip Codes

4-20 mA Analogue Output

Calibration

Programming

General Faults

No Display Indication

Troubleshooting steps for when the Remote Operator display shows no output.

AMPS or TEMP LED Flashing

Communication Loss Indication

Diagnosing and resolving communication loss issues indicated by display and RS485 LED.

4-20 mA Output Signal Issues

Troubleshooting steps for incorrect or absent 4-20 mA analogue output signals.

Motor Start Failure

Steps to resolve issues preventing the motor from starting.