Danfoss MCD Series User Manual

MCD Soft Starter Remote Operator
MG.17.E2.02 – VLT is a registered Danfoss trademark 7
Operation
 When used in conjunction with MCD 3000 starters
with serial numbers between xxxx06-482 and
xxxx07-xxx, Trip Codes C (Communications Failure), L
(FLC Out of Range) and Y (Incorrect Main Control
Module) are displayed as 1– on the Remote Operator.
These trip codes are displayed correctly on the soft
starter front panel.

Danfoss MCD Series Specifications

General

IP Rating	IP20
Frequency	50/60 Hz
Category	Controller
Rated Operational Current Ie	16-1600 A (depending on model)
Communication	Modbus RTU
Display	LCD
Input Voltage	200-480V AC
Output Current	16-1600 A (depending on model)
Storage Temperature	-40°C to +70°C
Humidity	5-95% (non-condensing)
Dimensions	Varies depending on model
Weight	Varies depending on model
Overload Protection	Electronic overload protection