Danfoss VLT 2800 Series Quick Start Guide

VLT
®
2800 Series
■ How to Disassemble
To disassemble the VLT, use a screw driver 1 x 6mm
(size 4).
1. Remove the front cover by using the screw driver,
see figure 3
2. Lift the flat cable using the screw driver. Be care-
ful not to touch the components on the control
card. See figure 4 for instructions
3. Remove the screws on the left side of the control
card
4. Gently remove the control card
5. Keep the control card in the ESD shielding bag in
which it was delivered
Fig. 3: Moving the front cover with a screw driver
Fig. 4: To remove flat cable, place screw driver
behind cable and pull gently
MI.28.A1.02 - VLT is a registered Danfoss trade mark
5
Disassembly

Danfoss VLT 2800 Series Specifications

General

Frequency	50/60 Hz
Communication Options	RS-485, Profibus DP
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short Circuit
Enclosure Rating	IP20
Storage Temperature	-25 to +65°C
Relative Humidity	5 - 95% RH, non-condensing
Altitude	Up to 1000m above sea level