Need help?Do you have a question about the Danfoss VLT 2800 Series and is the answer not in the manual?
General| Frequency | 50/60 Hz |
|---|---|
| Communication Options | RS-485, Profibus DP |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Short Circuit |
| Enclosure Rating | IP20 |
| Storage Temperature | -25 to +65°C |
| Relative Humidity | 5 - 95% RH, non-condensing |
| Altitude | Up to 1000m above sea level |
Crucial safety warnings and precautions before installation.
Steps for mechanical and electrical installation.
Setting motor parameters via the control panel.
Overview of control panel and initial setup procedures.
Procedure for optimizing motor parameters via AMT.
Configuration of display options and operating modes.
Setting parameters for motor characteristics and load.
Defining input references, output limits, and ramp settings.
Configuring digital and analog inputs/outputs.
Ensuring adequate ventilation and clearance for mounting.
Guidelines for EMC-correct wiring and connections.
Procedures for connecting mains, motor, and earth terminals.
Explanations of various display codes and messages.
Understanding warning and alarm codes and reset procedures.
Precautions for operating in harsh environments.
Adjusting output current based on ambient temperature.
Electrical specifications for mains supply.
Specifications for analog, pulse, digital I/O.
Table of parameters, factory settings, and data types.
Table of parameters, factory settings, and data types.
Table of parameters, factory settings, and data types.
Table of parameters, factory settings, and data types.
To Next Page