87MG.30.A7.02 - VLT
®
is a registered Danfoss trademark
Parameter description 0.. Operation and display
015
Setup selection,
Programming
(setup program)
Value:
Preprogrammed (Factory Set) [0]
Setup 1 (Setup 1) [1]
Setup 2 (Setup 2) [2]
Setup 3 (Setup 3) [3]
Setup 4 (Setup 4) [4]
(✭)Setup=Parameter 001
(Set-up=P001) [5]
The menu setup in which to program
(change data) can be selected.
It is possible to program the 4 menu setups
independently of which setup the VLT
®
frequency converter is operating in (se-
lected in parameter 001). This concerns
programming via the keyboard and the
serial bus (RS485).
Description of choices:
Preprogrammed contains the factory-set
data and can be used as data source if
the other setups are to be brought to a
known status. The language is always
English.
It is not possible to change data once this
setup has been chosen.
Setup 1-4 is 4 individual setups which can
be used as required. These can be pro-
grammed freely, irrespective of which
setup the VLT
®
is running in.
Setup = Parameter 001 is the preset value
normally used. This function can be
deselected for access to program during
operation in other setups than the VLT
®
is
currently running in.
NB! If data is changed in the setup the
VLT
®
is currently running in, the changes
have an immediate impact on the unit’s
function. This applies to both parameters
001 and 015.
✮ = Factory setting. Text in ( ) = Display text.
The figures in [ ] are used in bus communication.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
