Danfoss VLT 5000 Manual

VLT
®
5000 and Interbus CMD
1
MN.50.U1.02 - VLT is a registered Danfoss trademark
■■
■■
■ VLT 5000 Interbus card
The photo shows the Interbus card which can be
installed in VLT 5001 - 5500.
NameName
NameName
Name
IndicatesIndicates
IndicatesIndicates
Indicates
ColorColor
ColorColor
Color
OnOn
OnOn
On
OFFOFF
OFFOFF
OFF
CC/CR: Cable Check. Green Incoming bus active Incoming bus swicthed off
BA Bus Active. Green Bus active Bus stopped
RD: Status of outgoing bus. Red Outgoing bus stopped Outgoing bus active
TR: Transmit/Receive. Green PCP Communication running NO PCP Communication running
UL: Power OK. Green Voltage within permissible range No Voltage
All examples in this instruction are shown with a
PLC card as an Interbus master, but they are also
relevant to a PC system with an Interbus Master.
■■
■■
■ Abstract
This application note describes how to set up
Interbus communication between a Danfoss VLT
5000 frequency converter and Interbus CMD G4.
CMD stand for Configuration Monotoring and
Diagnostics.
This note will describe:
● Configuring of the VLT 5000 and CMD
● Drivecom profile
● PCP communication
Interbus connection for Bookstyle
IBS IN IBS OUT
IBS OUT IBS IN
Interbus connection for Compact
TR
TR
CC/CR
RD
BA
RD
UL
UL
CC/CR
BA
LED identification

Danfoss VLT 5000 Specifications

General

Frequency	50/60 Hz
Output Voltage Range	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overtemperature, Short circuit
Communication Interfaces	RS-485
Ambient Temperature Range	-10°C to +40°C
Enclosure Rating	IP20, IP21, IP55
Input Voltage	200-240V AC, 380-480V AC, 525-600V AC