Danfoss VLT 5102 User Manual

Pulse reference 121
Pulse reference 112
Pulse start/stop 69
Q
Quick discharge 202
Quick Setup 75
Quick-stop 110
Quick-stop 141
R
Ramp type 102
Ramp-down time 102
Ramp-up time 102
Read out via the serial communication 144
Reference 79
Reference function 103
Reference signal 101
Reference. 114
Reference/feedback unit 130
References - multi-references 192
References - single references 190
Relative reference 114
Relay 121
Relay 121
Relay outputs: 9
Relay outputs: 9
Reset 127
Reset 110
Resistor brake 125
Reversing 110
Reversing 142
RFI switch 58
Rise time 210
RS-485 65
S
Safety grounding 58
Safety interlock 112
Safety regulations 5
Selection of Setup 141
Selection of Setup, 111
Selection of speed 141
Setting of parameters 185
Setup 80
Setup change 69
SFAVM 137
single references. 115
single references. 116
Slow down 105
Software version 153
Speed control, closed loop 87
Speed control, open loop 87
Speed down 111
Speed PID 131
Speed up 111
Start 110
Start 141
Start anti-clockwise only 110
Start clockwise only 110
stator resistance 91
status word 166
Stop 110
Switching frequency 129
Switching pattern 137
T
Telegram profile 142
Thermistor 97
Thermistor. 114
Tightening-up torques and screw sizes 57
Time out 116
Torque characteristics 87
Torque characteristics: 6
Torque control, open loop 87
Torque control, speed feedback 87
Torque limit 105
Torque limit 105
Torque limit. 114
Trip locked 160
Trouble-shooting 156
Two wire start/stop 69
Two-wire transmitter 70
U
U/f characteristic 133
Unintended start 5
V
Vibration and Shock 215
VLT 5000 Series protection: 12
VLT 5000 Series protection: 12
VLT ordering number 153
Vlt output data (u, v, w): 6
VLT type 152
Voltage level 138
W
Warning against unintended start 5
Warning word 166
Warnings 160
Warnings 161
Warnings and alarms 160
VLT
®
5000 Series
234 MG.51.C5.22 - VLT
p
is a registered Danfoss trademark.

Danfoss VLT 5102 Specifications

General

Brand	Danfoss
Model	VLT 5102
Category	Media Converter
Language	English