VLT
®
8000 AQUA
415 Units relating to closed loop
(REF. / FDBK. UNIT)
No unit [0] °C [21]
✭% [1] GPM [22]
rpm [2] gal/s [23]
ppm [3] gal/min [24]
pulse/s [4] gal/h [25]
l/s [5] lb/s [26]
l/min [6] lb/min [27]
l/h [7] lb/h [28]
kg/s [8] CFM [29]
kg/min [9] ft
3
/s [30]
kg/h [10] ft
3
/min [31]
m
3
/s [11] ft
3
/h [32]
m
3
/min [12] ft/s [33]
m
3
/h [13] in wg [34]
m/s [14] ft wg [35]
mbar [15] PSI [36]
bar [16] lb/in
2
[37]
Pa [17] HP [38]
KPa [18] °F [39]
mWG [19]
kW [20]
Function:
Selection of unit to be shown on the display.
This unit will be used if Reference [unit] [2] or
Feedback [unit] [3] has been selected in one of the
parameters 007-010, as well as in the Display mode.
In Closed loop, the unit is also used as a unit for
Minimum/Maximum reference and Minimum/ Maximum
feedback, as well as Setpoint 1 and Setpoint 2.
Description of choice:
Select the required unit for the reference/feed-
back signal.
✭ = factory setting. () = display text [] = value for use in communication via serial communication port
MG.83.A2.02 - VLT is a registered Danfoss trademark
136
To Next Page
Loading...
