3.4.14 F-Frame Line Power Contactors 30
3.4.15 Motor Insulation 30
3.4.16 Motor Bearing Currents 31
3.4.17 Control Cable Routing 31
3.4.18 Access to Control Terminals 32
3.4.19 Electrical Installation, Control Terminals 33
3.4.20 Electrical Installation, Control Cables 34
3.4.21 Safe Torque Off (STO) 35
3.4.22 Switches S201, S202, and S801 36
3.4.23 Serial Communication 36
3.5 Final Set-up and Test
36
3.6 Additional Connections
38
3.6.1 Mechanical Brake Control 38
3.6.2 Parallel Connection of Motors 38
3.6.3 Motor Thermal Protection 39
4 Start-up and Functional Testing
40
4.1 Pre-start
40
4.2 Applying Power to the Equipment
41
4.3 Basic Operational Programming
41
4.4 Local Control Test
42
4.5 System Start-up
43
5 User Interface
44
5.1 How to Operate
44
5.1.1 Modes of Operation 44
5.1.2 How to Operate the Graphical LCP (GLCP) 44
5.1.3 Changing Data 48
5.1.4 Changing a Text Value 48
5.1.5 Changing a Group of Numeric Data Values 48
5.1.6 Changing Data Values, Step-by-Step 49
5.1.7 Readout and Programming of Indexed Parameters 49
5.1.8 Quick Transfer of Parameter Settings when Using GLCP 49
5.1.9 Initialization to Default Settings 49
5.1.10 RS-485 Bus Connection 50
5.1.11 How to Connect a PC to the Adjustable Frequency Drive 50
5.1.12 PC Software Tools 51
6 Programming
52
Contents Instruction Manual
Danfoss A/S © Rev. 2014-02-07 All rights reserved. MG37A222
To Next Page
Loading...
Need help?
General