What to do if Danfoss VLT PROFINET MCA 120 DC Drives power off?
If your Danfoss DC Drives show 'Power Off', it could be due to either no power supply or no link on the corresponding port. Ensure that the power is on and the link is active.
Why Danfoss VLT PROFINET MCA 120 power on with red light?
If your Danfoss DC Drives show 'Power On' and the indicator is red, this typically indicates an IP Address Conflict. Resolve the IP conflict.
General| Protection Class | IP20 |
|---|---|
| Communication Protocol | PROFINET |
| Series | VLT |
| Ambient Temperature | 0°C to 40°C |
| Storage Temperature | -25°C to 70°C |
| Relative Humidity | 5% to 95% (non-condensing) |
| Altitude | Up to 1000m above sea level |
Warning about high voltage and potential injury or death.
Regulations for safe handling, disconnection, and grounding.
Warning about risks associated with unintended motor starts.
Steps and items required for installing the fieldbus option in the frequency converter.
Precautions for achieving interference-free operation of the Ethernet network.
Configuration of basic communication parameters like IP address, subnet mask, etc.
Setting the unique station name (Host Name) for PROFINET devices.
Steps to configure the PROFINET controller, including GSD file import.
Key parameter settings for configuring the frequency converter with a PROFINET interface.
Description of PPO types for data exchange between controller and frequency converter.
Explanation of the control word bits for PROFIdrive profile commands.
Explanation of the status word bits for PROFIdrive profile notifications.
Explanation of control word bits for Danfoss FC profile commands.
Explanation of status word bits for Danfoss FC profile notifications.
Sequence for reading and writing parameters via acyclic communication.
Structure of data blocks for write/read parameter requests.
Covers critical parameters like Control Site, Source, Timeout, and Profile.
Configures bits 12-15 in the status word based on various conditions.
Configures control word bit 10 based on its active state (low or high).
Parameters 8-50 to 8-56 for selecting functions like Coasting and Start.
Configuration of IP address assignment and related network settings.
Example showing process data exchange using PPO type 6.
Checks and steps to resolve communication loss with the frequency converter.
Steps to diagnose why the frequency converter is not responding to control signals.
To Next Page
