3.1.6 Recommended Design Rules
While designing Ethernet networks special attention and caution must be taken regarding active network components.
While designing a network for line topology it is important to notice that a small delay is added with each switch in the
line.
It is not recommended to connect more than 32 frequency converter in a line. Exceeding the recommended design rules,
may result in unstable or faulted communication.
Illustration 3.9 Recommended Design Rules
How to Install Operating Instructions
14 Danfoss A/S © Rev. 2014-02-27 All rights reserved. MG90U302
33
To Next Page
Loading...
