[Alarm Log]
Displays an alarm list of the five latest alarms (numbered
A1-A5). To obtain more details about an alarm, use the
arrow keys to navigate to the alarm number and press
[OK]. Information is displayed about the condition of the
adjustable frequency drive or filter before it enters alarm
mode.
[Back]
Reverts to the previous step or layer in the navigation
structure.
Figure 5.8 Back Key
[Cancel]
Last change or command is cancelled as long as the
display has not been changed.
Figure 5.9 Cancel Key
[Info]
Displays information about a command, parameter, or
function in any display window. [Info] provides detailed
information when needed.
Exit Info mode by pressing either [Info], [Back], or [Cancel].
Figure 5.10 Info Key
Navigation keys
The four navigation keys are used to navigate between the
choices available in [Quick Menu], [Main Menu] and
[Alarm Log]. Move the cursor with the navigation keys.
[OK]
Is used for selecting a parameter marked by the cursor and
for enabling the change of a parameter.
130BT117.10
OK
Back
Info
Warn
Alarm
On
Cancel
Figure 5.11 Navigation Keys
Operation keys
For local control. Found at the bottom of the control
panel.
130BP046.10
Hand
on
O
Auto
on
Reset
Figure 5.12 Operation Keys
[Hand On]
Enables control of the adjustable frequency drive via the
GLCP. [Hand On] also starts the motor, and it is now
possible to give the motor speed reference with the arrow
keys. The key can be [1] Enabled or [0] Disabled via
0-40 [Hand on] Key on LCP.
The following control signals are active when [Hand On]
is activated:
•
[Hand On] - [Off] - [Auto On]
•
Reset
•
Coasting stop inverse (motor coasting to stop)
•
Reversing
•
Set-up select lsb - Set-up select msb
•
Stop command from serial communication
•
Quick stop
•
DC brake
NOTICE!
External stop signals activated with control signals or a
serial bus overrides a Start command via the LCP.
User Interface Instruction Manual
MG37A222 Danfoss A/S © Rev. 2014-02-07 All rights reserved. 47
5 5
To Next Page
Loading...
Need help?
General