2
READ THIS ENTIRE MANUAL BEFORE INSTALLATION & OPERATION BEGINS.
Unit Information. Enter the Model Number, Serial
Number, and the Date of Manufacture from the label
on your unit. This information is required for part or
warranty issues.
Model : ____________________________________
Serial: . ____________________________________
Date of Manufacture: _______________________
PRODUCT WARRANTY
Our comprehensive product warranty means more than a commitment to you; it’s also a commitment to the value of your
new Dannmar lift. For full warranty details and to register your new lift contact your nearest Dannmar dealer or visit
the Dannmar website.
What is not covered under this warranty:
a. Any failure that results from Purchaser’s abuse, neglect or failure to operate, maintain or service product in
accordance with instructions provided in the owner’s manual(s) supplied.
b. Any damage caused by overloading lift beyond rated capacity.
c. Items or service normally required to maintain the product, i.e. lubricants, oil, etc.
d. Items considered general wear parts such as rubber pads, lifting cables, etc. unless wear or failure is a direct result
of manufacturer defect due to material and/or workmanship.
e. Any component damaged in shipment or any failure caused by installing or operating lift under conditions not in
accordance with installation and operation guidelines or damaged by contact with tools or surroundings.
f. Motor or pump failure caused by rain, excessive humidity, corrosive environments or other contaminants.
g. Rusted components due to improper maintenance or corrosive environments.
h. Cosmetic defects that do not interfere with product functionality.
i. Damage due to incorrect voltage or improper wiring.
j. Any incidental, indirect, or consequential loss, damage or expense that may result from any defect, failure or
malfunction of BendPak Inc. product.
k. All electrical components (excluding power unit) are guaranteed for one year against defects in workmanship and/or
materials when the lift is installed and used according to specifications.
LIMITATIONS
Every effort has been taken to ensure complete and accurate instructions have been included in this manual. However,
product updates, revisions and/or changes may have occurred since this manual was published. BendPak reserves the
right to change any information without incurring any obligation for equipment previously or subsequently sold. BendPak is
not responsible for typographical errors.
To Next Page
Loading...
