D4-9 / D4-9X Four-Post Lifts 31 P/N 5900251 — Rev. A1— August 2021
Installing the Top Caps
The Lift comes with four Top Caps, one for the top of each Post. Each Top Cap holds one end of a
Lifting Cable.
There are two Left Top Caps and two Right Caps; the top plates are marked with an L or an R.
To install the Top Caps:
1. Take a Top Cap, pick the corresponding Post you want to install it onto, orient it correctly, and
then push the Top Cap down into the top of the Post.
Top View of the Lift. Not drawn to scale. Size of Top Caps exaggerated for clarity.
2. Secure the Top Cap in place using four Bolts and Washers.
3. Install the other three Top Caps the same way.
⚠ WARNING Make sure all four Top Caps are firmly bolted into place.
To Next Page
Loading...
