DB-70 Automatic Wheel Balancer 24 P/N 5900261 ā Rev. A1 ā January 2021
Balance Mode Indications
Pushing the R
key cycles through the available balance measurement modes. There are six dynamic
balancing modes and one static balancing mode available. The mode chosen is dependent on the
type of wheel.
Mounting a Wheel on the Shaft
When you want to balance a Wheel, the first step is to mount it on the Shaft.
Important: All Wheels should be mounted so that the inside (the side of the Wheel that goes
closest to the Vehicle) goes on the Shaft first.
Important: Do not hammer on the Quick Nut to tighten. This will damage the Quick Nut, which
is not covered under the warranty.
Front- Cone Mount.
The preferred
method, as it generally produces the most
accurate balancing results.
To Next Page
Loading...